[هادی]

میخواستم اطلاعاتی در مورد نحوه تست تانژانت دلتا داشته باشم ممنون میشم اگه راهنمایی کنید.
میخواستم اطلاعاتی در مورد نحوه تست تانژانت دلتا داشته باشم ممنون میشم اگه راهنمایی کنید.

Topic

[?]

معمولا تست تانژانت دلتا روي ترانسفورماتور هاي فشار قوي انجام مي شود كه بوسيله دستگاه انجام مي شود ،البته دركتابهاي اندازه گيري در اين رابطه توضيح كامل داده شده.

[حمید]

گزیده ای از یکی از کتب مرجع در ارتباط با تست تلفات عایقی یا tan? در زیر آمده است. The PF (Power Factor) insulation tests were used in the laboratory since the early 1900s by cable manufactures, and in the field for testing bushing since 1929. The DF (Dissipation Factor or tan ?) is based on the Schering bridge which was developed also in the early 1900s to evaluate insulation by separating the capacitive and real components of the charging current. Today, the PF and DF tests are considered to be synonymous because they both refer to the AC dielectric loss test. PF and DF are but two of the several measurable characteristics that can be obtained from an AC dielectric loss test used for evaluating the condition of the insulation system. Both of these tests are effective in locating weaknesses in the electrical insulation and hazard in the power apparatus before impending failure. PF and DF tests are not go-no-go tests, and can measure dielectric loss, capacitance, and AC resistance of the insulation of the electrical apparatus. These tests can measure the presence of bad insulation even when there may be a layer of good insulation in series with the bad insulation. These tests provide information on the overall condition of the insulation in terms of a ratio (i.e., PF or DF value of insulation) that is independent of the volume of the insulation being tested. Moreover, they provide assessment of the insulation under normal frequency (60 Hz) operating conditions which is not time dependent like the direct current (DC) voltage tests. The PF and DF tests do not overstress the insulation and can determine if the insulation is slowly degrading by comparison with previous year

[امید یزدی]

تست تانژانت دلتا به وصیله دستکاه omicronبا اعمال ولتاژ dc12کیلو ولت وجریان حدود 800امپر به سمت فشار قوی ترانس وصل و کابل دیگر به فشار زعیف وصل میشود سری بعد بین فشار قوی و بدنه ترانس وبار دیگر بین فشار ضعیف وبدنه بار اخر فشار ضعیف و قویی جمپر شده وتست زده میشود

[Author]

Replies